Darts to big on "11 - Bodice Sloper Full Fit X"

Mike

Hi,

I guess I am doing something wrong here, although I just selected a garment and a measurement set (from the example sets). I tried to use "11 - Bodice Sloper Full Fit X" with the "Adult Mature X - E" measurement set. This resulted in the two attached patterns:

The lower dart seems way too big on front and back (and even intersects the outline on the front piece), resulting in a way too small waistline.

Could you kindly look into it?

Regards,
Mike

Lori

Hi Mike,
I just ran it and got the same results. Give me a bit to figure this out.

Thanks for bringing it to my attention.

Lori

Mike,
I found the issue and it is very, very bad. The measurements that were being copied out of the library had some duplicate values.

We have marked all sets with duplicate values as deleted. Your Adult Mature X - E set should now be gone from your list. Please take a fresh copy from the library to add to your account, then run #11 again.

This issue would have affected not only #11 but all drafts. I am so grateful that you've reported. We had no idea this was happening.

Mike

Sorry I could report back earlier, due to the login problem. This one seems to be fixed now. Thanks

Community Rules & Guidelines

Website Terms & Conditions