Adding Fullness

rhonda

I am in the process of creating a Puffed Tulip Sleeve. I think the "Adding Fullness" is the process that would do this. I created the spread points and stay points, but am lost on the order in which to select the spread points, stay points and intermediary points. Am I going about this the wrong way? Any help would be greatly appreciated!

By the way, do you think you will ever be doing more videos on how to tutorials for your program? I thoroughly enjoyed your previous ones.

Thank you.

rhonda

Attached is a screenshot

Lori

rhonda
I think the fullness tool is what you want. Are you adding the fullness at the cap, the hem or both? If you're only adding to the cap or hem, you'll set the value for the opposing points to zero.

Have you checked out the manual for help?
Fullness

I think your only intermediary point is the one guy on the far right. It looks like you have a curve there. Make sure you turn that into a polyline before you slash it or you'll have a mess.

I am working on a very comprehensive learning resource, but it will be a while before it is done. I appreciate your interest.

rhonda

I am adding fullness at the cap and then want to increase the height of the cap after I obtain fullness. I did change the right curve to a line but still ran into a problem (see attached).

I first added the spread points 1, 2, 3 and 4 and hit enter. Then I hit the second set of stay points 5, 6, 7 and 8, then enter. For intermediary point, I hit 9 and enter. It then asks for a secondary intermediary point. I can't select 9 again nor can I continue on to set measurements.

Community Rules & Guidelines

Website Terms & Conditions